The overview mode, like the satellite view, only This mode is useful for getting information on the The overview mode shows the entire combat area The topographic mode shows the area around The R key toggles your radar between topographic
Standing very still will cause hover units to disappear from radar. Also, in dogįighting, topographic radar is an excellent tool for the enemy as well. On units within the range of the pilot’s topographic radar. Many action commands such as Attack, Service, and Build can only be executed Pilot must take into account with regards to his/her topographic radar. There are certain considerations that every ISDF The numbering will alsoīe shown in the topographic radar display. Of units on which the command may be executed. When certain commands are chosen, such as attackĪnd service, the command menu will present the pilot with a numbered list Units are displayed with a number corresponding to their command channel. Vehicles and encampments are displayed in red, friendlies in green. Radar information is also shown on this map. A floating directionalĬompass is superimposed on the map to allow pilots to chart their courses Pilots to topographic hazards as well as to ensure that the planet’s environmentĬan be used as an asset to skilled dogfighters. Many hours of surveying were done and the latest satellite Radar The topographical map is located to the lower left of I hold down the Ctrl key while pressing F3. I press F1, F2 and F3 to select all three groups. I have one Turret each in groups 1, 2, and 3. Selecting the group you want them to go into. Select the groups you want toĬombine by pressing their function keys. Group Units that are of the same type may be taken from different Combining Units From Two or More Groups Into a Single The units that were in group 1 are now in group 5.
Select all the units using the 1 through 10 keys. I want to switch the units from group 1 to group 5. Then press the number key to select the units.įinally, press Ctrl and a function key to assign the units to that group. Moving Units to Another Group You can change what group number a unit is in by pressingĬtrl and a function key. This selects the unit you are pointing at only, not its group. Alternately, you can point at an individual unit and press the That will give you a list of individual units that you can Selecting Individual Units in a Group Hold down the Ctrl key while pressing the function keyįor a group. You can toggle the selection of any group off or on by Selecting Multiple Groups You can select multiple groups by pressing their associatedįunction keys before pressing a number key to give a command or the Tab These units will be automatically grouped. Press the key to build that unit one time forĮach unit that you wish to build into the group. Building Multiple Units Into a Group Hold down the Shift key while you order your Recycler A group can only contain units of the same type. You select a group by pressing the function key associated There are up to ten groups, and each one corresponds to a particularįunction key, F1-F10.
Grouping/Ungrouping Units Selecting a Group In Battlezone 2™, up to ten similar units can exist
You can move units between command channelsĪnd group like units into a single command channel.
BATTLEZONE 2 RELAY BUNKER CAMERA GLITCH FREE
New units will automatically go into the free commandĬhannel with the lowest number. Pressing the keysġ through 0 will give the units in that command menu an order pressing Units in a command channel will open their command menu. Selects all the units grouped in the first command channel. The units in a command channel can be accessedīy pressing the F1 through F10 keys. To access units even though they are outside your field of view. Organized into one of ten command channels.
0 kommentar(er)
